46
SETUP
Diaplay ID auto setup
Automatically sets an ID number. An ID number is automatically assigned to a display connected via DIGITAL LINK.
Status
Displays the implementation status of Display ID auto setup.
Operating: the auto setup is in progress.
No connection: DIGITAL LINK is not connected. (No connection can be
detected)
Error: a wrong DIGITAL LINK connection has been made.
Wait: the auto setup has yet to be implemented.
Finished: the auto setup has been completed.
Display ID Auto Setup
Status
Wait
DIGITAL LINK daisy chain
1 / 2
Display ID
1
Network control / IP address
On
Off
192.168.0.8
DIGITAL LINK
DIGITAL LINK
Off
Built-in
Serial ID / Terminal
Serial out terminal
Controller out terminal
Controller ID / Terminal
IR OUT
Display ID
Start
Changing network control
Changing serial/IR terminal
Auto
Yes
Yes
DIGITAL LINK Daisy Chain (
A
/
B
)
A: Displays the i-th unit of the displays connected via DIGITAL LINK.
B: Displays the total number of displays connected via DIGITAL LINK.
Display ID:
Displays an ID number obtained by the auto setup.
Network control / IP address: (
A
/
B
)
A: Displays the disable / enable state of the Network control function.
B: Displays the IP address of this display.
Serial ID / Terminal: (
A
/
B
)
A: Displays the disable / enable state of the ID control function for serial communication.
B: Displays which terminal to use for input for serial communication.
Serial out terminal:
Displays which terminal to use for output for serial communication.
Controller ID / Terminal: (
A
/
B
)
A: Displays the disable / enable state of the ID control function for remote control operation.
B: Displays which sensor / terminal to use for remote control signal input.
Controller out terminal:
Displays which terminal to use for remote control signal output.
Start:
Starts the auto setup of a display ID.
Display ID:
Auto: The display ID will be set automatically, based on the order of connected by DIGITAL LINK.
1 ~100 : Sets the origination of the display ID.
Changing network control:
Sets whether to change the network settings or to retain the current settings as the auto setup of display ID is
implemented.
Options: No: retains the settings.
Yes: Set to “On” to “Network control”.
Changing serial/IR terminal:
Sets whether to change the control terminal settings for RS232C/IR or to retain the current settings as the auto
setup of display ID is implemented.
Options: No: retains the settings.
Yes: For the display connected by DIGITAL LINK, set to “DIGITAL LINK” for the settings of each input-
outputterminals of RS232C and controller.
Note: For the display connected only input side or output side, the setting of connected side is changed. For the
display connected by DIGITAL LINK, set to “DIGITAL LINK” for the settings of each input-output terminal of
RS232C and controller.