11
Cautions when installing multi displays
Securing gaps between displays
The displays slightly expand due to heat after the power
is turned on. When installing multiple displays, securing a
gap of 0.5 mm is required on the left, right, top and bottom
respectively between displays in anticipation of display
contact caused by expansion.
If the gap is less than 0.5 mm, image failure may occur
due to display distortion caused by heat expansion.
A
A
A: Gap between displays (left, right, top and bottom
respectively), 0.5 mm
Do not allow the corners of displays to hit each other.
After the displays are attached to the brackets at the
back and the positions are adjusted, do not adjust the
positions of the front sides using the plate, etc.
Doing so may cause image failure due to display
distortion.
Front side
Back side
Plate
Lateral side