54
Operating Instructions
12 Configure the settings of the servers [Server]
IMPORTANT
•
When entering the host name for “FTP server address”, it is necessary to configure the DNS settings on
the [Network] tab of the “Network” page. (section 13)
[User name]
Enter the user name (login name) to access the FTP server.
Available number of characters:
1 - 32 characters
Unavailable characters:
" & : ; \
Default:
None (blank)
[Password]
Enter the password to access the FTP server.
Available number of characters:
0 - 32 characters
Unavailable characters:
" &
Default:
None (blank)
[Control port]
Enter a control port number to be used for the FTP server.
Available port number:
1-65535
Default:
21
The following port numbers are unavailable since they are already in use.
20, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[FTP mode]
Select “Passive” or “Active” for the FTP mode.
Normally, select
“Passive”. When it is impossible to connect after select “Passive”, try to connect after selecting
“Active”.
Default:
Passive
12.3 Configure the settings relating to the NTP
server [NTP]
Click the [NTP] tab on the “Server” page. (section 6)
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on
this page.
IMPORTANT
Use an NTP server when the more accurate time & date setting is required for the system operation.
[Time adjustment]
Select the time adjustment method from the following. Time adjusted by the selected method will be used as the
standard time of the unit.
Manual:
Time set on the [Basic] tab on the “Basic” page will be used as the standard time of the unit.
