![background image](http://html.mh-extra.com/html/panasonic/section-700/section-700_user-manual_270161088.webp)
Chapter 3. System Features
Section 700 - Operation
Page 3-42
DBS Manual - Revised April 2000
DBS-2.3/9.2-700
Remote Maintenance
(All Versions)
Description
The DBS can be programmed from a remote terminal or from a remote PC.
Remote programming can be accomplished using the Remote Programming
Mode or by using Panasonic’s PCAS (Personal Computer Administration
System) or DBS Manager software.
Remote Programming Mode
(All Versions)
Description
Remote Programming Mode uses a “dumb” terminal or a PC to access the
DBS. This method of remote maintenance is less sophisticated and more
difficult than using PCAS or DBS Manager.
You can enter the Remote Programming Mode through any of these three
methods:
• By using a local PC and communications package to connect directly to
the DBS serial port
• By dialing into the system through a direct DISA trunk
• By dialing into the system through a regular CO trunk, then requesting the
operator to enter the Remote Programming ID Code.
Operation
Terminal Programming Through a Direct Connection
When programming from a terminal connected to the RS-232C (SMDR) port,
perform the following steps:
1. Make certain the cables are configured and connected as outlined in
Section 300.
2. Make certain the DBS is in the SMDR mode by entering the following
code from the attendant port:
ON/OFF
#93
3. Enter your terminal communications program and make sure your PC’s
data communications settings match those of the DBS.
Summary of Contents for Section 700
