Section 700 - Operation
Chapter 3. System Features
DBS-2.3/9.2-700
DBS Manual - Revised April 2000
Page 3-23
• FF1 (System): DISA Outbound Call ID Code 1
• FF1 (System): DISA Outbound Call ID Code 2
• FF2 (Trunk): DISA Auto Answer
• FF2 (Trunk): DISA Start Time
• FF2 (Trunk): DISA End Time
To program an incoming code from an attendant phone:
In addition to the DISA ID Setting in FF1, the following procedure can be
used to program an incoming code.
1. Press
the
ON/OFF
key.
• The phone issues intercom dial tone.
• The
ON/OFF
LED lights.
2. Press
the
CONF
key.
3. Dial
“#7.”
4. Enter the DISA code.
5. Press
the
HOLD
key.
6. Press
the
ON/OFF
key.
The
ON/OFF
LED goes off.
Hardware Requirements
• An MFR card is required for DISA. The MFR card is required to detect
DTMF tones entered via the DISA connection.
Considerations
• DISA can be used to access extensions as well as outside numbers.
• Once an incoming DISA code is entered, you cannot blank it out without
entering the programming mode.
• Busy override cannot be used for a DISA line.
• With CPC-A and CPC-B Versions 2.0 to 2.1, DISA calls cannot access
hunt groups.
Summary of Contents for Section 700
