Panasonic PV-D4733S-K, Service Manual

Page: 160 / 274

smoothly between the upper and lower guides of the P4 post.
2. If necessary, adjust Black Screw (B) clockwise until the tape begins to
curl at the lower edge of the P4 post. Then adjust the screw
counterclockwise until the curling is eliminated.
Fig. M4
6.2.2.2.3. AUDIO CONTROL HEAD HEIGHT ADJUSTMENT
The height of the Audio Control Head replacement part is preset at the factory.
Purpose:
To be sure the tape runs properly along the Control Head.
Symptom of Misadjustment:
If the control signal is not properly picked up, Servo Operation cannot
be achieved. A Blue screen will be seen in Playback.
This confirmation is required when the Audio Control Head is replaced.
1. Play back a T120 cassette tape and check that the lower edge of the
tape runs approximately 0.25 mm above the lower edge of the Audio
Control Head.
2. If necessary, adjust Black Screws (A) and (B) clockwise to lower the
tape or counterclockwise to raise.
Fig. M5
48