Chapter 2
Getting Started — Connecting
58 - ENGLISH
f
To use the <SDI 2 IN/1 OUT> terminal or the <SDI 4 IN/3 OUT> terminal as an output terminal, set the [DISPLAY OPTION] menu
→
[SLOT
IN]
→
[SDI MODE] to [OUTPUT].
Connecting example: Computers
This is an example when the optional Interface Board for DisplayPort 2 input (Model No.: ET-MDNDP10) is
installed in the slot.
Control computer
Computer
Computer
Control computer
Computer
Attention
f
When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f
Setting the [DISPLAY OPTION] menu
→
[SLOT IN] is required depending on the connected external device or the input signal.
f
For the DisplayPort cable, use a DisplayPort cable that conforms to the DisplayPort standards. When a cable that does not conform to the
DisplayPort standards is used, images may be interrupted or may not be projected.
f
Switching of the setting in the [DISPLAY OPTION] menu
→
[DVI-D IN]
→
[EDID SELECT] may be required depending on the connected
external device when DVI-D signal is input.
f
Switching of the setting in the [DISPLAY OPTION] menu
→
[HDMI IN]
→
[EDID SELECT] may be required depending on the connected
external device when HDMI signal is input.
f
For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. However, when the following 4K video signal
exceeding the supported transmission speed of the HDMI High Speed cable is to be input, use the HDMI cable supporting the high speed
transmission of 18 Gbps such as the one with Premium HDMI cable authentication.
g
A video signal with high specification color depth and gradation such as 3840 x 2160/60p 4:2:2/36-bit or 3840 x 2160/60p 4:4:4/24-bit
Images may be disrupted or may not be projected when a video signal exceeding the supported transmission speed of the HDMI cable is
input.
f
The <HDMI IN> terminal of the projector can be connected to an external device equipped with a DVI-D terminal using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and image may not be projected.
f
The <DVI-D IN> terminal supports single links only.
f
If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
