- 243 -
∫
It is not a malfunction in following cases
∫
Power
Others
Troubleshooting
The lens or LCD monitor fog
up.
≥
This is due to condensation. This is not a malfunction. Please refer to page
When the camera head is
shaken, it makes “rattling”
sound.
≥
This is the sound of the lens moving and is not a defect.
This sound will no longer be heard when the unit is turned on and switch to
Recording Mode.
There is abnormal sound in
the camera head.
≥
There will be operation sound during boot, switching of operation mode, or
zoom operation. This is not malfunction of the camera head.
Object seems to be warped.
≥
Object seems to be warped slightly when the object moves across the image
very fast, but this is because the unit is using MOS for the image sensor. This
is not a malfunction.
When the flash is fired during
shooting, only the top or
bottom of the screen becomes
lighter
≥
With a MOS image sensor, the shooting timing differs slightly between the top
left and bottom right of the screen. This means that when the flash is fired, the
bottom of the screen will become lighter in the field concerned and the top will
become lighter in the next field. This is not a malfunction.
Problem
Check points
This unit cannot be turned
on.
This unit does not stay on
long enough.
Battery runs down quickly.
≥
Connect the Camera Head Optional cable correctly. (
)
≥
Charge the battery again to ensure it is sufficiently charged. (
)
≥
In cold places, the battery using time becomes shorter.
≥
The battery has a limited life. If the operating time is still too short even after
the battery is fully charged, the battery has worn out and needs to be
replaced.
≥
Securely connect the AC adaptor to the AC outlet.
≥
Confirm if the AC cable of the AC adaptor is correctly connected.
This unit cannot be operated
though it is turned on.
This unit does not operate
normally.
≥
Remove the battery or AC adaptor, wait about 1 minute and then reconnect
the battery or AC adaptor. Then about 1 minute later, turn on the unit again.
(Conducting the above operation while the SD card is being accessed may
damage the data on the media.)
≥
If normal operation is still not restored, detach the power connected, and
consult the dealer who you purchased this unit from.
“ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN.” is
displayed.
≥
The unit has automatically detected an error. Restart the unit by turning off
and on.
≥
The unit will be turned off in about 1 minute if the unit is not turned off and on.
≥
Repair is needed if it is repeatedly displayed even if it is restarted. Detach the
power connected, and consult the dealer who you purchased this unit from.
Do not attempt to repair the unit by yourself.
The status indicator flashes a
few times in red.
≥
An error such as an attempt to perform a recording operation while an SD
card is not inserted has occurred. Check the event log. (
AG-MDR25PJ.EJ(DVQP1328ZA)_E.book 243 ページ ２０１７年５月２２日 月曜日 午後６時１４分
