![background image](http://html1.mh-extra.com/html/panasonic/pn261693d/pn261693d_manual_3736554032.webp)
32
The following describes how to use several commands on this screen.
N
Displays the next page.
Press N (command) to display the next page.
P
Displays the previous page.
Press P to display the previous page.
A
Each port can be set to enabled or disabled.
1. Press A, and then the appearance of the command prompt becomes “Select port
number to be changed>”. After that, enter the port-number to change. (Press 0 to
change all the ports, simultaneously).
2. The appearance of the command prompt becomes “Enable or Disable admin status for
port # (E/D)>”. Press E to enable, and D to disable it. Enter the necessary contents. As
the configuration is changed, the top part of the display is changed automatically.
M
Configures full/half-duplex of each port.
1. Press M, and then the appearance of the command prompt becomes “Enter port
number >”. After that, enter the port-number to be changed. (Press 0 to change all the
ports, simultaneously.)
2. The appearance of the command prompt becomes “Enter mode for port # (A/N)>”.
Press A to use the auto negotiation mode, and N otherwise.
3. Press N, and then the appearance of the command prompt becomes “Enter speed for
port # (10/100/1000)>”. After that, enter the communication speed to configure.
4. If you press 10 or 100, the appearance of the command prompt becomes “Enter duplex
for port # (F/H)>”. Press F (Full duplex) for the full duplex, and H (Half duplex) for the
half duplex. After that, the configuration is changed, and then the top part of the display
becomes changed automatically.
Mode:
A:
Sets to the auto-negotiation mode.
N:
Sets the fixed configuration. (Support is not available for the fixed speed
of 1000BASE-T.)
Speed:
10:
Sets to 10Mbps.
100:
Sets to100Mbps.
1000:
Sets to 1000Mbps.
Duplex:
F:
Configures full-duplex.
H:
Configures half-duplex.
F
Configures to enable or disable the flow control.
1. Press F, and then the appearance of the command prompt becomes “Select port
number to be changed>”. After that, enter the port-number to be changed. To change
all the ports simultaneously, press 0 on that.
2. The appearance of the command prompt becomes “Enable or Disable flow control for
port # (E/D)>”. Press E to enable, and D to disable it.
After that, the configuration is changed, and then the top part of the display becomes
changed automatically.
S
Configures to enable or disable Auto MDI/MDI-X.
1. Press S, and then the appearance of the command prompt becomes “Enter port
number >”. After that, enter the port-number to be changed in the range from 1 to 26.
(Press 0 to change all the ports, simultaneously.)
2. The appearance of the command prompt becomes “Enable or Disable Auto-MDI for
port # (E/D)>”. Then press E to enable, and D to disable it.
After completing the configuration, the top part of the display becomes updated.
Q Returns to the top menu.