№
SX-DCT00221 -
2-
Panasonic Corporation
4. Specification
4.1 General specification
Bas
ic
sp
ecific
a
tion
Allowed range of supply voltage fluc-
tuation
±
10 %
Control method
Speed control by CS signal, PWM sine wave driving system
Ambient conditions
Ambient temperature
0 - +50
℃
(free from freezing)*5
Ambient humidity
20
～
85 % RH or below (free from condensation)
Location
Indoor
（
No corrosive gas, A place without garbage, and dust
）
Altitude
Not greater than 1000 m
Vibration
Not greater than 4.9 m/s
²
(10-60 Hz)
Storage temperature
-20
℃
~65
℃
(max temperature 80
℃
72 hr, Free from freezing)*1
Storage humidity
20
～
85 % RH or below (free from condensation)
F
unc
tio
n
Number of positioning points
4 points(Travel distance, speed, acceleration time, decelera-
tion time, and relative/absolute can be set per point)
Positioning resolution
288 pulse/rotation(Accuracy: Within - 5 degrees at 20
℃
at no load)
Input signal*3
6 points
Output signal*3
2 points (Open collector)
Communication function via
RS485
Setting of parameter, monitoring of control condition and the like
are enabled with RS485 interface. Max 31 units.
Communication
function via RS232C
Setting of parameter and monitoring of control condition are ena-
bled with commercial PC. (When connecting a commercially avail-
able PC, an optional connecting cable is necessary. If PC has no
RS232port, RS232-USB converter is required.)
Digital Keypad(sold separately) Available
Regenerative Break
Optional regenerative resistor is available.*6
Protective function
Overload, Overcurrent, Overvoltage, Undervoltage , System error, Set-
ting change warning, Over-speed, Sensor error, Overheat, Position er-
ror, External forced trip, Position error counter overflow, RS485 commu-
nication error, Operation execution error, Digital keypad communication
trouble, user parameter error, and system parameter error
Pe
rf
or
ma
nc
e
Speed control range
30 – 4000 r/min *4
Overload rating
Inverse time-lag overload protection
Protection level 115 (Torque reference)
Torque reference 150, 1 minute
Permissible length for
motor cable
10 m or less (with optional extension cable
）
*2
Permissible length for
control cable
3 m or less*2
Cooling system
Self cooling
Mass (k
g
)
100 W or less:0.37, 200 W or more:1
*1 Please note that dew condensation easily occurs when the temperature decreases.
*2 It is the maximum length in our evaluation environment and it does not guarantee the operation in the
customer's use environment.
*3 The function of signal can be changed by Digital key pad, “Panaterm for BL” or RS485 communication.
*4 It is the range that can control the speed, and the rotation quality such as smoothness is affected by the
load condition and gain setting.
*5 Ambient temperature is measured at a distance of 50 mm from the product.
*6 External regenerative resistor: DV0P2890/DV0PM20068(100 V/200 V)
＊
Take the signal input (I1, I2 and so on) for Start and Stop basically. The power ON and OFF may cause
short lifetime in the internal circuit.
* Trip means that a protection circuit operates and stops.
