№
SX-DCT00221 -
7-
Panasonic Corporation
5.5 Connector for control signals (I/O)
JST S10B-PASK-2 or equivalent
Terminal
number
Terminal
symbol
Terminal
name
Default
Description of function
1
I1 *1
Signal input 1 Run start
Select a function with Pr50.
In turning on signal, short between “I1” and “GND”. (In-
put logic can be changed by Pr54.)
2
I2 *1
Signal input 2 Point desig-
nation 1
Select a function with Pr51.
In turning on signal, short between “I2” and “GND”. (Input
logic can be changed by Pr55.)
3
I3 *1
Signal input 3 Home sensor
Select a function with Pr52.
In turning on signal, short between “I3” and “GND”. (Input
logic can be changed by Pr56.)
4
I5 *1
Signal input 5 Forced trip
Select a function with Pr70.
In turning on signal, short between “I5” and “GND”. (Input
logic can be changed by Pr72.)
5
I6 *1
Signal input 6 Forced trip
Select a function with Pr71.
In turning on signal, short between “I6” and “GND”. (Input
logic can be changed by Pr73.)
6
GND
Signal
ground
Common ground terminal for control signal.
7
I4 *1
Signal input 4 Forced trip
Select a function with Pr53.
In turning on signal, short between “I4” and “GND”. (In-
put logic can be changed by Pr57.)
8
+5V
Power supply
Set 50 mA or below
9
O1 *1 Signal output
1
Trip output
Open collector output. Choose a function with
Pr5C. (Output logic can be changed by Pr5E)
10
O2 *1 Signal output
2
In-motion sig-
nal
Open collector output. Choose a function with
Pr5d. (Output logic can be changed by Pr5F)
*1
Function of input/output can be changed by PANATERM
for BL or the Digital key pad. Default is shown.
■
Do not touch the terminals of the control circuit and do not connect or disconnect the I / O connector
while energizing. It may malfunction due to static electricity.
■
When extending the control signal cable, set it to 3 m or less.*2
■
To prevent unexpected situations due to poor contact etc. install and wire so that stress such as pulling is
not applied to the connector via cable. Confirm that the caulking of the wire is secure and that the connector
is inserted securely.
■
Use a twisted wire or a shielded wire for the wire connected to the control circuit.
■
Please separate the electric wire connected to the control circuit from the power line.
*2 It is the maximum length in our evaluation environment and it does not guarantee the
operation in the customer’s use environment.
