Panasonic KX-TVP200, Installation Manual

Page: 36 / 408

INSTALLATION
36 Installation Manual
g)
Wait until the "warning" appears on the screen.
h)
Set the Rotary Switch back to position 0.
CAUTION
If the Rotary Switch is not reset to position 0 after initialisation, all programming will be
lost when the voice processor loses power!
6.
Perform Quick Setup (see Section 5 CUSTOMISING THE SYSTEM).
7.
Check Quick Setup:
• The Power Indicator on the Voice Processor should be solid.
• The screen output should be: [On Line].
If you do not see the "On Line" message, check the following:
• The line cord to the Voice Processor has 4 conductors.
• The programming on the KX-TD816 or KX-TD1232 is correctly set in System
Programme [117].
• The programming on the KX-TD500 is correctly set in the "1-4 VPS (DPT) Port
Assignment" screen.
8.
Set up Class of Service (COS) for each user. Customise voice prompts if necessary (see
Appendix B SYSTEM ADMINISTRATOR'S GUIDE).
9.
Perform Administrative Programme through a personal computer (see Appendix B
SYSTEM ADMINISTRATOR'S GUIDE).
Do not turn the power off while the VPS is activated so as not to cause malfunction.
To turn the power off after installing the VPS, unplug the power cord from the VPS a
few minutes after disconnecting station wire(s).
CAUTION