Registering the PS
The PS must be registered to the PBX before it can be used. Programming of both the PS and PBX is required.
A PT with multiline display (e.g., KX-T7636 6-line display) is required to perform the PBX system programming.
Note
For details about system programming using a PT, refer to "2.3.2 PT Programming" in the Feature
Guide, and "2.1 PT Programming" in the PT Programming Manual.
Entering the PBX System Programming Mode Using a PT
Administrator Level
#
= 1234
System Password for Administrator—
for PT Programming
Programming No.
3 digits
PROGRAM/
PAUSE
Note
means default value.
PS Registration
One PS can be registered to a maximum of 4 different PBXs.
[690]
PS No.*
1 to 4 digits
END
(HOLD)
ENTER
ENTER
To the PS
operation
below
Extn. No.
* Without an EMEC card installed: 001 to 256.
With an EMEC card installed: 001 to 512.
Using the KX-TCA155/KX-TCA255/KX-TCA256/KX-TCA355
Select
"Setting Handset".
Select
"Register H/set".
Select
"Registration".
Select
"Base 1–4".
"
Please wait
".
"
Enter Base PIN
".
Press POWER
for 2 seconds.
C.Tone
4 digits
PIN for PS Registration
226
Installation Manual
2.10.7 Connecting a Cell Station to the PBX
Summary of Contents for KX-TDA600 - Hybrid IP PBX Control Unit Max. 1008 Ports
