2.2.17 Surge Protector Installation
Overview
A massive electrical surge can be caused if lightning strikes a telephone cable 10 m above ground, or if a
telephone line comes into contact with a power line. A surge protector is a device that is connected to a trunk
to prevent potentially dangerous electrical surges from entering the building via the trunk and damaging the
PBX and connected equipment.
To protect the system from electrical surges, we strongly recommend connecting the system to a surge
protector that meets the following specifications:
–
Surge arrestor type: 3-electrode arrestor
–
DC spark-over voltage: 230 V
–
Maximum peak current: at least 10 kA
Additionally, proper earthing is very important for the protection of the system (refer to "2.2.10 Frame Earth
Connection").
Many countries/areas have regulations requiring surge protection. Be sure to comply with all applicable laws,
regulations, and guidelines.
Installation
Trunk
Trunk
Trunk
Extn.
Extn.: Extension line
Surge
Protector
Terminal
Board
PBX
Frame
Earth
Earth
Extn.
SLT
PT
PT-interface CS
CS
Installation Manual
123
2.2.17 Surge Protector Installation
Summary of Contents for KX-TDA600 - Hybrid IP PBX Control Unit Max. 1008 Ports
