2.10.8 Wall Mounting
Mounting the KX-TDA0158CE
WARNING
•
Make sure that the wall that the unit will be attached to is strong enough to support the unit
(approx. 310 g). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers) included with the unit.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths
or metal plates in the wall.
•
When this product is no longer in use, make sure to detach it from the wall.
CAUTION
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Use cables that are fire-resistant or fireproof.
•
The CS and the cables should never be placed near or over a radiator or other heat source.
•
Do not bundle cables that are connected to the CS with the AC power cords of machines located
nearby.
•
Make sure the cables are securely fastened to the wall.
1.
Place the reference for wall mounting (KX-TDA0158CE) on the wall to mark the 2 screw positions.
2.
Install the 2 screws and washers (included) into the wall.
Note
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Hook the CS on the screw heads.
Washer
Drive the screw
to this point.
Installation Manual
231
2.10.8 Wall Mounting
Summary of Contents for KX-TDA600 - Hybrid IP PBX Control Unit Max. 1008 Ports
