Panasonic HD-PLC DA-PU100, Administrator'S Manual

Page: 61 / 67

DA-PU100 Series Administrator's Manual
61
About the influence on other electric appliances
Symptom Possible Cause Remedy
Noises entering the
shortwave radio /
lighting fixtures with a
dimming function and
touch lamps do not
work.
This product may affect shortwave
radio, lighting fixtures with a dimming
function and touch lamps.
Please connect these electric
appliances to another outlet or use as
far away from this product as possible.
Keep the short-wave radio antenna or
main unit away from the wall. If noise
still enters, switch the frequency of the
shortwave radio to another frequency.
The product of another
specification does not
work.
This product may affect other types of
PLC adaptor.
Connect PLC adaptors of a different
type to another power outlet or use as
far away from this product as possible.
About the Internet
Symptom Possible Cause Remedy
Cannot connect to the
Internet.
"HD-PLC" network is not connected. Check that the PLC indicator of all
adaptors in the same network turns on
green. If the PLC indicator is lit in
orange, refer to the explanation of the
problem (page 31).
Not connected to the Internet. Please connect the PC and the router
etc. directly with the LAN cable and
check whether you can connect to the
Internet. If you cannot connect, please
check the connection set up by PC or
router.
Others
Symptom Possible Cause Remedy
The PLC adaptor is
warm or hot.
It is not abnormal.
(There are times when it will feel a bit
hot in summer compared to winter)
If it is abnormally hot, unplug the power
plug and consult your dealer.
Factory Reset
This function will erase all of the settings in this product and initialize it to the factory default settings.
1.
Connect the product to a power source.
2.
Press and hold the CLEAR button for more than 3 seconds
• When initialization starts, PLC indicator, LAN indicator, MASTER indicator blinks, then each
indicator goes out.
•
When the PLC indicator, the LAN indicator, and the MASTER indicator are all illuminated,
initialization is complete.
Note
• After the indicators light, wait at least 30 seconds before terminating power to the product.