Panasonic HD-PLC DA-PU100, Administrator'S Manual

Page: 19 / 67

DA-PU100 Series Administrator's Manual
19
2.4 Install and Wiring this product
2.4.1 Installation of PLC adaptor (implementation)
•
Install individual PLC adaptors to the determined construction site.
•
When installing to the place sequentially from the master, you can install it while confirming the
PLC link state.
Notice
• During installation work, do not allow foreign objects (wire scrap, concrete wall materials, etc.) to
get inside the equipment.
•
One PLC adaptor must be set as the master adaptor and the other PLC adaptor must be
registered as a terminal adaptor in the master adaptor.
2.4.1.1 When fixing this product to the DIN rail
•
Use the DIN rail lever (
①
) to secure it to the DIN rail (
②
).
•
DIN rail lever: When pulling out from the DIN rail, pull it in the direction of the arrow.
2.4.1.2 When a fixing bracket is used
Notice
•
The weight of this product is about 260 g. Please confirm in advance that there is sufficient
strength at the installation site.
•
Check the strength of the installation site for long-term use.
• If the strength of the installation site is insufficient, install appropriate reinforcement material in the
installation location.
• For the outline of this product, refer to "Dimensions" (page 65).
1. Set the fixing brackets (
①②③
) to the main body with screws (rear side)
2. Remove the terminal cover
3. Use the screw holes (3 places) to fix this product to the installation location.
•
For wiring, refer to "Connection of power supply" (page 20)
4. Attach the terminal cover.
①
②
③
①