Troubleshooting
SQT0801
106
Troubleshooting guide
The following messages or service numbers appear on the
front panel display when something unusual is detected.
The remote control and main unit are using different codes.
Change the code on the remote control. (
>
100)
Selected titles in the USB HDD are being converted.
Do not disconnect the USB HDD from this unit.
TV Guide data is being downloaded.
If there is no change after switching the unit to standby mode
and turning it on, consult the dealer.
You cannot delete items on this disc. The disc may be
damaged.
• The disc is dirty. (
>
12) The unit cannot read the disc.
• The lens cleaner has finished cleaning.
Press [
<
OPEN/CLOSE] on the main unit to eject the disc.
You cannot write to this disc. The disc may be damaged. Use
a new disc.
• Displayed when the unit is started and is switched to
standby mode.
• There was a power failure or the AC plug was disconnected
while the unit was on. The unit is carrying out its recovery
process. Wait until the message disappears.
There are already 32 timer programmes. Delete unnecessary
timer programmes. (
>
35)
The USB device is drawing too much power. Remove the
USB device.
Update of the software (firmware) is started. You cannot
operate the unit until the update is complete. (
>
95)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or the timer
recording starts. (
>
95)
The media is not supported.
The software (firmware) is being updated. You cannot
operate the unit until the update is complete. (
>
95)
The unit is hot. The unit switches to standby for safety
reasons. Wait for about 30 minutes until the message
disappears.
Install or place this unit with good ventilation.
(When a disc is not inserted) A malfunction has occurred. The
unit is trying to restore to the normal operation. Once the
message disappears you can use the unit again. If it remains
displayed, consult the dealer.
HDMI cannot be output because it is connected to a model
that does not support copyright protection.
Due to the current disc not having authorised copyright
information, video output is not performed.
(When a disc is inserted) There was something unusual
detected with the disc or the unit. The unit is trying to restore
to the normal operation. Once the message disappears you
can use the unit again. If it remains displayed, consult the
dealer.
The unit fails to operate properly. Press [
Í
/I] on the main unit
to switch the unit to standby mode. Now press [
Í
/I] on the
main unit again to turn the unit on.
The HOLD function is activated. (
>
98)
There is something unusual. (The service number displayed
after H and F depends on the unit’s condition.)
Reset the unit as follows:
1
Disconnect the plug from the household mains socket,
wait a few seconds, then reconnect it.
2
Press [
Í
/I] to turn the power on. (The unit may be fixed.)
Request service from the dealer. Inform the dealer of the
service number when requesting service.
Messages on the front panel display
BD
(“
∑
” stands for a number.)
CONV
GUIDE
HARD ERR
NoERAS
NoREAD
NoWRIT
PLEASE WAIT
PROG FULL
REMOVE
START
SW-DL
UNSUPPORT
UPD
/
(“
∑
” stands for a number.)
U59
U61
U76
U77
U88
U99
X HOLD
H
or F
(“
∑
” stands for a number.)
DMRBWT955GL_eng.book 106 ページ ２０１５年２月３日 火曜日 午前１０時３分
