51
DVD-ROM & CD-R/RW Drive
z
Removing
Hold down on the center spindle (C) and gently lift up on the edge of the disc.
4
Close the disc cover.
NOTE
z
When B's Recorder finishes writing, the disc cover opens automatically.
z
If a hand is on the disc cover or the display is closed, and the disc cover is prevented
from opening, the drive will not be accessed correctly. In this case, open and close
the disc cover once, and then re-attempt access.
z
If the vibration of the DVD-ROM & CD-R/RW drive is excessive, check to see if the
disc is inserted correctly, and check that the disc is in good condition. If the disc is
good and inserted correctly, set [CD/DVD Drive Speed] to [Low] in the Setup Utility.
Or, when writing to a disc using B's Recorder, you can minimize vibration while writing
by setting the writing speed at [8x] or less.
z
For AutoPlay CDs:
• If an AutoPlay CD does not start after the computer resumes from the standby or
hibernation modes, remove the disc from the drive, then reinsert the disc again after
a 15 second wait.
• An AutoPlay CD may start during file access, depending on the status of the disc.
z
When playing back movies from a disc, note that smooth playback may not be
possible in some cases.
Power-saving Mode
If the DVD-ROM & CD-R/RW drive has not been accessed within 30 seconds, the drive motor
will automatically shut down to reduce the power consumption. When the DVD-ROM & CD-
R/RW drive is accessed once again, the power of the drive motor is turned on. However,
approximately 30 seconds are required until data is actually read from the disc.
