2
Plug in the AC adapter, and fully charge your battery.
Use a spare battery if you have one.
If you have neither the AC adapter nor an extra battery, power the computer off or do not power on.
If the hibernation function is set
C o m p u t e r
goes off
(at approx. 0% capacity)
If the hibernation function is not set
(at approx. 9% capacity)
Red indicator lights
Beep sounds**
(at approx. 9% capacity)
Red indicator lights
Beep sounds
(at approx. 4% capacity)
(at approx. 4% capacity)
Hibernation Mode
**
When disabling the speakers with the
Setup Utility (or pressing
+
),
the warning beep is also disabled.
When the Remaining Battery Charge Becomes Low
Perform the following:
The battery has been changed. Please refer to the following about the battery.
Use the Battery Indicator to Check on the Battery Status
Battery Status
B a t t e r y I n d i c a t o r
B a t t e r y S t a t u s
Charging
Fully-charged
Battery charge is low (the charge is less than approx. 9% capacity)
Battery pack or charger may not be working properly.
Check your connections. If the problem persists, consult your
nearest Panasonic dealer.
Unable to recharge due to violation of temperature limits
(
P..3)
Refreshing
Refreshing required
O r a n g e *
G r e e n *
R e d
B l i n k i n g r e d *
B l i n k i n g o r a n g e f o r 5
s e c o n d s a f t e r t h e A C
a d a p t e r i s c o n n e c t e d *
B l i n k i n g o r a n g e * *
B l i n k i n g g r e e n * *
*
When the AC adapter is connected, you must wait a few seconds before the LED indicator turns on.
** Only using the Ni-MH battery pack (CF-VZS250A or CF-VZS252).
N O T E
When using the optional CD-ROM pack:
Recharging is temporarily stopped when the drive is being accessed. In the case, the battery indicator goes off temporarily. In
addition, recharging is temporarily discontinued when the CD-ROM autoplay function is enabled. For more information, please
read the operating instructions that is supplied with the CD-ROM pack.
Getting a detailed reading
+
N O T E
When the battery indicator remains red (or a 99% reading is displayed) for an extended period of time, the actual
remaining battery level and the displayed level may differ. Should this occur, charge the battery until the indicator is
green, then completely discharge the battery.
When the battery pack is not in the computer,
is displayed.
90 ~ 100%
65 ~ 90%
35 ~ 65%
10 ~ 35%
[Blinking]
The battery pack is not installed or
the remaining battery charge is not
known.
Battery Power
(
"Operating Instructions" P.12~17)
(
P.3)
