13
Battery Indicator
Power low
Hibernation function is enabled:
- The beeper sounds at the same time.
- The computer automatically enters the hibernation
mode a few minutes after the beeper sounds.
Hibernation function is disabled:
- The beeper sounds several minutes later.
- The computer automatically turns off a few minutes
after the beeper sounds.
Please continue normal use.
Please continue normal use.
Green
Orange
Charging
Fully charged
Action
Battery Status
Battery Indicator
"Power management" conserves battery power and enables the computer to be oper-
ated to the maximum extent possible.
Connect the AC adapter to the computer.
Replace the main battery with a fully charged
one.
If recharging is not possible at this time, imme-
diately save any open files on your disk and turn
off the power.
When the indicator remains red for a long time,
proceed with refreshing unless there has been a
sudden change in temperature.
The battery or AC adapter may not have been
connected properly.
Please wait until refreshing finishes. Press ESC
if you wish to abort.
Blinking green
Blinking orange
Blinking orange
for 5 seconds after
the AC adapter is
connected.
Refreshing required
Refreshing
The temperature is outside the range of approximately
5°C to 35°C (41°F to 95°F).
Please wait until the temperature falls within the
allowable range.
NOTE
Certain applications may not run when "Power Saving" is set to "Advanced" or "Standard".
If this is the case, set "Power Saving" to "OFF".
When Windows is activated, select [Start]-[Settings]-[Control Panel]-[Power], and confirm
that the "Allow Windows to manage power use on this computer." check box has been checked
at "Power". The default setting is "checked".
Conserving Battery Power
Battery Power
Red
Refresh the battery pack. (
P.17)
Blinking red
The computer enters the standby mode immediately after
+
Standby
are pressed.
In this mode, the HDD motor and display is turned off.
In order to achieve maximum battery power, in the setup utility, set "Power Saving"
in "Power Management" to "Advanced".
Make the proper connections. (
P.8,15)
If the problem persists, contact the Panasonic
Service Center. (Trouble may have occurred in
the battery, charging controller, etc.)