24
Follow the procedure below to specify operating environment settings (device port
addresses and IRQs, passwords security, drive protection and reduced power con-
sumption) for the computer.
Setup Utility
Press [F1] when the messages "Press F1 for Setup" appear.
(These messages appear only for a few seconds. Setup utility does not
run if you delay pressing [F1].)
Power on.
Startup
System Setup
Power Management
Supervisor Setup
Save settings
Restore Settings
Load Default Settings(PnP)
Load Default Settings(NonPnP)
Exit Setup
Setup Utility
Specify your operating environment settings (device port addresses and
IRQs, password security, drive protection and power consumption) and
select [Save Settings].
Select [Exit Setup].
Refer to the On-line Help.
( Please press [F1].)
The password to protect what has been registered for "Supervisor Setup".
User Password :
NOTE
MEMO
The password when the computer starts up.
You can set the 3-type passwords in order to prevent unwanted access to your computer. (When the computer is waiting for
inputting the password, the four battery indicators blink. )
Supervisor Password :
Suspend Function :
When [Fn] +[F7] is pressed, this function maintains the state of the computer ( i.e., data remains on
memory ) until the power is turned back on. It enables you to resume an unfinished operation imme-
diately. The function works only when the battery pack is kept in the computer or the AC adapter is
connected.
When the power is turned off in this mode, the data in memory is saved onto the hard disk, and
when the power is turned back on, the computer is restored to the state it was in before the power
was turned off. When this function is enabled, all data is saved even when no power is being
supplied to the computer. When the computer is turned on, its previous state(i.e., when the power
was last turned off) is displayed.
Hibernation Function :
The password when you leave your desk for a short period. After [Alt] + [Ctrl] + [F9], [F10] , [F11]
or [F12] (set by "Key Combination") are pressed, only by inputting the coffee break password can the
computer resume operation. The coffee break password also serves as the user password. Therefore,
set the user password first to enable the coffee break password.
Coffee break Password :
Before attempting to remove or install a RAM module, multimedia pocket or port replicator etc. disable the hibernation
function.
The system may not recognize a mouse, modem, PC card, IrDA or other serial devices when its power is turned back on,
after the system had been in the suspend or hibernation mode. In this case, re-initialize the device or computer.
When using the touch pad or external mouse (serial or PS/2 type), do not enter the suspend or hibernation mode. The next
time the computer resumes, it may not be possible to use these devices.
Do not press the power switch or enter the suspend or hibernation mode while the hard disk or MP indicator is on since the
computer is still accessing the drive.
The suspend and hibernation functions cannot be used under an operating system other than Windows 95 or when diagnos-
tics program (DIAG25) or Setup utility has been started.
Do not use the suspend or hibernation function when an application program which uses the CD has been started. Instabil-
ity in operation may result.
If the system enters the suspend or hibernation mode upon pressing [Shift], the state of the keyboard remains with pressing
[Shift] when the system resumes. In this case, press [Shift] again and release it.
