Panasonic AK-HRP200G, Operating Instructions Manual

Page: 35 / 44

34 35
System connection diagram
System connection configuration
• The unit can be connected to a CCU, remote camera, or camera recorder via a serial connection or IP connection.
• Up to 19 CCUs, remote cameras or camera recorders can be controlled.
• With a serial connection, only one of either a CCU or remote camera can be connected.
It is not possible to use a CCU serial connection and a remote camera serial connection at the same time.
• A configuration with one serial connection and 18 IP connections is possible.
• The ROP setup software provided with this unit must be installed on a personal computer and configured in order to use IP connection with CCUs,
remote cameras, and camera recorders. For details on ROP Setup Software, refer to Operations and Settings.
Please make sure that the version of the ROP setup software is Ver. 3.0.0.0 or higher when making IP connection to a camera recorder.
Operation
mode
* 1
Connection configuration
Serial connection
IP connection
Use of
ROP Setup
Software
CCU Remote camera Camera recorder
Serial
connection
mode
Configuration with CCU connected with a
serial connection

(1 device only)
(Connection not
possible)
(Connection not
possible)
(Do not connect) Not required
Configuration with remote camera
connected with a serial connection
(Connection not
possible)

(1 device only)
(Connection not
possible)
(Do not connect)
Configuration with camera recorder
connected with a serial connection
(Connection not
possible)
(Connection not
possible)

(1 device only)
(Do not connect)
IP
connection
mode
Configuration with IP connections only (Do not connect) (Do not connect) (Do not connect)

(Total of up to 19
devices)
Required
Configuration with a combination of a
CCU connected with a serial connection
and CCUs and remote cameras
connected with IP connections

(1 device only)
(Connection not
possible)
(Connection not
possible)

(Total of up to 18
devices)
Configuration with a combination of a
remote camera connected with a serial
connection and CCUs and remote
cameras connected with IP connections
(Connection not
possible)

(1 device only)
(Connection not
possible)

(Total of up to 18
devices)
Configuration with camera recorder
connected with a combination of a serial
connection and IP connection
(Connection not
possible)
(Connection not
possible)

(1 device only)

(Total of up to 18
devices)
*
1
For details on operation modes, refer to Operations and Settings.
CCU connections
„ „
Serial (ROP cable) connection
12V IN LAN RS-422 PREVIEW
CCU
SIGNAL GND
ROP cable
AK-HRP200
Connection example:
AK-HCU200
1. Connect the CCU connector on this unit to the ROP
connector on the CCU rear panel using a dedicated ROP
cable (sold separately).
2.
After having connected all the components, turn the CCU
main power on, and then turn the camera on.
<Note>
• If no camera is connected, the number of CCU functions that this unit
can control is limited.
• Turn off the CCU before disconnecting the ROP cable.