– 166 –
Chapter 9 Network Connection — Network settings
t
All of the IP address, subnet mask, and default gateway must be correctly set.
If a warning [CANNOT ACCESS GATEWAY!] appears at the termination of the setting screen, contact the administrator of the network you use.
t
If you do not use default gateway and DNS, set them to [0.0.0.0].
t
DHCP and DNS may not function properly depending on the network environment.
P2 browser function settings and connection status check
P2 browser function settings
1
Configure the settings in the main menu
→
[NETWORK SETUP]
→
[NETWORK FUNC]
→
[HTTP SERVER].
[BROWSE]:
Enables the P2 browser function.
[BROWSE (
+
CTRL)]:
Enables the HTTP server function, starting and stopping recording at the terminal side, and preset control of time code or user
bits.
[DISABLE]:
Disables the HTTP server function.
Network operation status display (mode check function)
Push the <DISP/MODE CHK> switch on the camera towards the <CHK> side twice to check the network operation status in the mode check
[FUNCTION] screen.
For details, refer to “[FUNCTION] screen” (page 146).
FTP client function setting
By connecting the camera to network using wireless LAN (wireless access point connection) or wired LAN, you can transfer clips to a server device on
the network.
Client settings
To transfer clips with the FTP client function, you need to set the connection destination and other settings in advance.
1
Set each item in the main menu
→
[NETWORK SETUP]
→
[CLIENT SERVICE].
[FTP SERVER URL]:
Sets the name or address of the server to connect to. (Up to 500 characters)
[LOGIN USER]:
Sets the user ID to connect to. (Up to 31 characters)
[LOGIN PASSWORD]:
Sets the password to connect to. (Up to 15 characters) The set password cannot be displayed on the unit.
[SSH]:
Sets when transferring files using SSH.
f
[ENABLE]:
Uses SSH.
f
[DISABLE]:
Does not use SSH.
@
@
NOTE
t
The FTP client function does not function when [WLAN] is set in the main menu
→
[NETWORK SETUP]
→
[NETWORK SEL], and [DIRECT] is set in
the main menu
→
[NETWORK SETUP]
→
[WIRELESS PROPERTY]
→
[TYPE].
Operation check tools, status indication, and initialization
You can check FTP client network connection status as follows.
r
Checking connection (PING)
1
Press the <THUMBNAIL> button.
The thumbnail screen is displayed.
2
Select [PING] in the main menu
→
[NETWORK SETUP]
→
[NETWORK TOOL].
3
Press the control stick.
4
Perform status check of the connection with the address that has been set.
When a connection is confirmed, [PING SUCCESSFUL!] appears.
If a connection cannot be established within approximately 30 seconds, [PING FAILED!] appears. The log may indicate the cause of a failure.
r
Displaying the connection log (LOG)
1
Select [LOG DISPLAY] in the main menu
→
[NETWORK SETUP]
→
[NETWORK TOOL].
2
Press the control stick.
The log appears.
3
After checking the log, press the <EXIT> button.
The setting menu screen returns.
@
@
NOTE
t
Some operations may not generate any information in the log.
t
The password is indicated as [
*
] in the log.
r
Displaying the status
1
Select [STATUS DISPLAY] in the main menu
→
[NETWORK SETUP]
→
[NETWORK TOOL].