Panasonic AG-CX350E, Operating Instructions Manual

Page: 79 / 199

– 79 –
Chapter 4 Operation — Menu settings
[720 × 480p] Outputs in 720 × 480p.
[720 × 576p] Outputs in 720 × 576p.
(Factory setting: [1920 × 1080p])
@ @
NOTE
t For the combinations that can be set, refer to “Format that can be output from the <HDMI> terminal” (page 151).
[HDMI TC OUT]
Sets if the time code information is output or not in the output from the <HDMI> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[HDMI REC REMOTE]
Sets if the recording operation against the external equipment connected to the <HDMI> terminal (such as recorder) is to be controlled or not. This can
be set when [HDMI TC OUT] in [HDMI OUT] is enabled.
[ON] Controls the recording operation of the external equipment.
[OFF] Does not control the recording operation of the external equipment.
(Factory setting: [OFF])
@ @
NOTE
t This cannot be set when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] is set to [INTERVAL].
[HDMI OUT CHAR]
Sets whether to superimpose the character to the output from the <HDMI> terminal.
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
[HDMI OUT ZEBRA]
Sets whether to superimpose the zebra signal to the output from the <HDMI> terminal. The settings of the zebra signal follow the zebra signal settings
in the [VIDEO OUT/LCD/VF] menu
→ [EI ASSIST].
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
[HDMI OUT HDR]
Sets the output image from the <HDMI> terminal.
[SDR] Outputs in the standard dynamic range.
[HDR] Outputs in the high dynamic range.
(Factory setting: [HDR])
@ @
NOTE
t The setting is fixed to [SDR] when set to following menu.
- [SYSTEM] menu
→ [REC FORMAT] → [480-59.94i/AVCHD SA]
- [SYSTEM] menu → [REC FORMAT] → [576-50.00i/AVCHD SA]
- [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [OUT FORMAT] → [720 × 480p]
- [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [OUT FORMAT] → [720 × 576p]
t When the [SCENE FILE] menu → [GAMMA MODE SEL] is set to anything other than [HLG], the camera image is output in the standard dynamic
range.
[AV OUT]
[OUTPUT SW]
Enables/disables the output from the <AV OUT> terminal.
[ON] Outputs the video and audio.
[OFF] Does not output the video and audio.
(Factory setting: [ON])
[AV OUT CHAR]
Sets whether to superimpose the character to the output from the <AV OUT> terminal.
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [ON])