Panametrics TMO2D, User Manual, Page: 51 / 101

TMO2D User’s Manual 43
Chapter 4. Basic Programming
• Cal:err (total or per reading drift error)
Follow the steps below to enter the Auto Cal Parameters submenu.
.
4.8.5.1 Set Auto Verification?
Auto verification is similar to automatic calibration. The solenoids are still tripped to allow the calibration gases to
flow to the transmitter. However, if the calculated drift is less than a preprogrammed amount, the TMO2D will not
store the new drift data into memory. If the drift is beyond the verification limit and no cal error occurs, then the
TMO2D applies new calibration data and sets a new calibration flag.
CALIBRATION MENU
Auto Cal Parameters?
Press [YES] to enter the Auto Cal Parameters submenu.
Enable AutoCal:
[YES] no
Press [YES] to enable the AutoCal function.
AUTO CALIBRATION MENU
Set Auto Verification?
Then use the [NO] or arrow keys to scroll through the ten options within the
submenu.
AUTO CALIBRATION MENU
Set Time Interval?
AUTO CALIBRATION MENU
Set AutoCal Mode?
AUTO CALIBRATION MENU
Set Cal Gas Data?
AUTO CALIBRATION MENU
Set Settling Time?
AUTO CALIBRATION MENU
Set Error Handling?
AUTO CALIBRATION MENU
Perform AutoCal?
AUTO CALIBRATION MENU
Reset Drift?
AUTO CALIBRATION MENU
View Drift Curve?
CALIBRATION MENU
Done?
Press [YES] to exit the Calibration Menu and return to the Main Menu.