Panametrics TMO2D, User Manual, Page: 19 / 101

TMO2D User’s Manual 11
Chapter 2. Installation
Figure 6: Wiring Connections to TB1 Block
CAUTION!
Do not make any connections to unassigned or unused terminals.
2.3.3.2 CE Mark Compliance
IMPORTANT: CE Mark compliance is required only for units used in EU countries.
For CE Mark compliance, you must use shielded cable and connect the shield to the stand off as shown in Figure 7 on
page 12. After you make all the necessary electrical connections, seal the unused cable entry holes with standard
conduit plugs or their equivalent.
Note: If you make the modifications as discussed here, your unit will comply with the EMC Directive 2004/108/EC.
Note: For CE compliance, the I/O cables must be shielded. The shields are to be grounded within the TMO2D to the
closest location. Shielded cable is not required when installations include metal conduit.
2
3
4
1
+24 V/1 AMP 1
Return 2
Oxygen 3
None 4
Red
Black
White