Pamex Enkore Series, Project Implementation Manual

Page: 14 / 88

Plan your programming cards
The area tree is now ready to be linked to physical locks. Pamex Enkore locks
support WPA2 encryption to connect to the Wifi AP. When a lock is scanned by a
programming card, the preferred Wifi AP SSIDs will be loaded into the lock from
programming card. A programming card may save 1 ~ 5 SSIDs.
Normally, you only have to scan one time for a lock during its lifetime. The reasons to
re-scan programming card will be :
● MF-Admin server ip is changed after go-live phase : This should be a rare
case and usually can be avoid. If the MF-Admin Server ip has to be changed,
then you have to make new programming cards and all the locks have to be
programmed again.
● Some Wifi AP SSID changed : For those locks in the range of changed wifi
APs, you have to scan them with new programming card which has the new
SSID in it.
● Locks have been reset to factory default.
When any of the above cases happened, we recommend you to contact with the
reseller for help.
In SIMPLE project, we assume that you have two Wifi APs with SSID = AP1 and
SSID = AP2. In real world, depending on the size of your project. you may have tens
to hundreds of Wifi APs. Therefore, prepare below table is recommended :
Wifi AP SSID WPA2 Key
(32 characters)
Rooms in Range Programming
Card
AP1 12345678 Unit A Card 1
Unit B Card 1
Unit C Card 1
Unit D Card 1
AP2 abcdefg Public Area P Card 1
For SIMPLE project, AP1 and AP2 can be saved into one programming card.
Programming card can be created by using MF-Admin Server and you may create
14