Install the Mandatory Front Slot Cards
32
• Installing the Hardware
Palo Alto Networks
2.
Attach the provided ESD strap to your wrist and plug it into one of the ESD ports located on the
front of the chassis. The ESD ports are located along the bottom row of the chassis and you will see
three ports, any of which can be used. For details on the ESD port location, see “Front Panel (AC)”
on page 6.
3.
Remove the LPC from the anti-static bag and slide it into slot 8 ensuring that the handles are in the
open position. When the card is about 1/4” from being fully inserted, adjust the levers to align with
the chassis and then close the levers to seat the card in place as shown in Figure 16.
Figure 16. LPC Install/Remove Illustration
4.
Tighten the thumb screws on each side of the LPC to secure it to the chassis. Use a Phillips-head
screw driver if necessary.
Note: The LPC uses a double lever on each side of the card. After loosening the
thumb screws, you must pull the inner lever toward you to unlock the outer lever
from the chassis and then pull the outer lever to release the card from the chassis.
When installing the card, when you push the outer lever in, it will lock the inner
lever. The left and right inner levers have a micro-switch that will power off the
card as soon as they are pulled to unlock the outer lever.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
PA-705
0
SMC
SMC
LPC must be installed in slot 8
