PALAZZANI RAGNO XTJ 32 / C, Operation And Maintenance Manual

Page: 82 / 210

Palazzani
Palazzani Industrie spa
OM 371 pag 18 Cap 3
Fig. 3.15 Fig. 3.16
Remember that, in case of manual stabilization, it is easier and safer to
adjust the levelling by lowering the stabilisers instead of lifting them.
Always check that the plates are solidly positioned on the ground (it is
dangerous to put them on gutters, near scarps, on soft or water grounds, etc.)
To retract the sabiliser, check that the green light on the turntable (Fig. 3.17) is
lighted on. Select the key 1 in fig. 3.2 on stabilisers symbol, act the accelerator
lever part 6 in fig 3.6 and the lever 1 to stabilisers lifting direction until the
complete retraction. In alternative, act manually on every stabiliser in the following
way: switch pos. 10 fig. 3.6 on “Man”, act, preferably, two levers contemporarily
(the two front or the two rear ones) and push the accelerator lever softly, until the
complete retraction.
Fig. 3.17
NOTE:
In normal working conditions platform is to be hoisted 10 ÷ 40 cms. over flat
ground
Do not excede 40 cm from the ground on flat ground.
Stabilization on steps gives no problem, it is only important to level the
platform.
On a steep slope, where there is a risk of sliding, it is recommended to place some
woods under the legs, in order to be within 2° (see spirit level) before levelling