PALAZZANI RAGNO XTJ 32 / C, Operation And Maintenance Manual

Page: 74 / 210

Palazzani
Palazzani Industrie spa
OM 371 pag 10 Cap 3
3.4 PLATFORM WORKING WITH ELECTRIC MOTORS
This energy source use is recommended when the machine works indoor or where
the exhaust gas or noise are forbidden and when the energy saving is important.
Where possible, it is recommended to branch always the platform to an electric
source, in fact, el.motors can be used alternatively to diesel engine, for small aerial
movements and, eventually, for recovery in emergency (i.e. diesel breakdown)
Starting procedure:
ƒ on main control desk (Fig. 3.2) rotate the key (item 8) on pos. 1 (oil and el.
tension warning lights)
ƒ branch the electric plug (fig. 3.4) and socket (16A)
ƒ verify that one of the "STOP" push-buttons is not pressed
ƒ now, acting on one control lever, electric motor run
ƒ
it is also possible to stop electric motor, by acting on the same STOP push-
button of the diesel engine, or by rotating key on OFF position
ƒ electric motor re-starts, when the push-button is re-set by rotation and you
act on one control lever
Fig. 3.4
NOTE:
For the efficient functionning of magnetothermic differentials switch (life-savers)
on the machine, the electricity plug mus be safely connected to the ground and be
on a normal box; do not use flying cables sometimes existing on the working sites.
During the machine displacement on the ground, keep the max attention to not