Painless 60608, Installation Manual

Page: 40 / 52

39
9. Cruise Switch Section
:
The cruise switch section of this harness provides power, cruise on/off,
resume/accelerate and set/coast wires. Connect these wires as follows. Most late
model GM steering columns years 1983-1993 already have or can be retrofitted with
a cruise control switch. See figure below for the proper connection of these wires to
a factory GM cruise control switch part number 25111262. This harness kit does not
include the connector needed because it has been discontinued by Delphi.
a. The pink wire #957 is power (connector pin A).
b. The grey wire #973 is the cruise control on/off switch signal (connector pin B).
c. The blue wire #974 is the cruise control set/coast switch signal (connector pin
D).
d. The grey/black wire #975 is the cruise control resume/accelerate switch
signal (connector pin C).
10. Brake Switch Section
:
Provided with the parts kit is a four pin
brake switch. Connect the brake switch
wires according to the diagram to the
right. Use some of the heat shrinkable
spade connectors provided in the bubble
pack.
This switch must be mounted so that the
plunger is pushed into the switch when the
brake pedal is at rest.