Digital Video Recorder
11
NOTE:
The FEN (For Easy Network) function allows you to connect to the DVR from remote sites using either
the dynamic IP addresses or the domain name. For the FEN function to work properly, the DVR should be registered
on the FEN server, and the FEN server settings should match the settings registered on the FEN server. Any
changes on the FEN server might cause improper operation.
NOTE:
The FEN registration is limited to only one FEN server. The DVR cannot be registered to multiple FEN
servers.
NOTE:
When FEN function is enabled, it is not necessary to set up port forwarding manually. However, remote
connection to the DVR might not be available depending on the network connection environment of the DVR or
remote system when the FEN function is enabled. If it is the case, you should set up port forwarding for the DVR
manually in the NAT (Network Address Translation) device to which the DVR is connected.
–
Use RTSP:
Enables the RTSP service.
y
Set up network port:
Click the button and set up network port number.
y
Internet Protocol (TCP/IP) properties:
See
Appendix 1 — Network Setup
.
System alert
Clicking each tab of
S.M.A.R.T.
,
Stop recording
and
Login Fail (3 times)
and enabling each function causes the
system alert as follows:
y
S.M.A.R.T. tab – Set up alert, S.M.A.R.T. Log:
Causes the system alert when S.M.A.R.T. log occurs. This is
supported only when the installed hard disk drives support S.M.A.R.T. (
Self-Monitoring, Analysis and Reporting
Technology) Monitoring program (Internal hard disk drives only)
– Delay time for the first inspection after system starts:
Set the standby time until the system performs the first
inspection after the system starts.
– Inspection Interval:
Set the inspection interval.
– Threshold temperature for alert:
Set the threshold temperature of hard disk drives. The DVR leaves S.M.A.R.T.
log when the temperature of hard disk drives exceeds the defined threshold.
– S.M.A.R.T. Log:
Displays the list of S.M.A.R.T. log.
Summary of Contents for PDR16HR-RMT-RT
