4.
風管膠帶
四.安裝步驟
1.請準備安裝位置及空間
。
2.測量出風口及電源線孔的大小
，
然
後再鑽孔
。
3.櫥櫃需加強本機固定的地方
，
建議
使用木條強化在櫥櫃內底部
。
4.請先卸下不鏽鋼濾網
，
再用十字起
子移除兩側修飾板
，
並取下不鏽鋼
油杯
。
5.
依安裝位置設置四支木螺釘
。
6.安裝時用木螺釘扣上之後
，
將油機
與櫥櫃用螺絲鎖緊
，
讓油機與櫥櫃
安全不會掉落
。
7.裝設電源
。
8.安裝風管並用風管膠帶密封
。
9.檢查風管處是否緊密及其他功能是
否正常
。
10.依序將不鏽鋼油杯
、
修飾板及不鏽
鋼濾網重新安裝回去
。
櫥櫃安裝說明:(如圖一)
不鏽鋼濾網
與修飾板
油杯
圖一
電源線孔
木條
木螺釘與鑰匙孔
風管圈孔
IV. Installation Procedures
Hood is designed for installation under a kitchen cabinet.
See Fig.1 for details.
1. Prepare duct location on hood(vertical or
horizontal) .
7. Install electrical.
8. Install ductwork and seal with aluminum duct tape.
10. Reinstall grease tray., side panels and baffle filters.
9. Power up hood and check for leaks around duct tape and test all functions.
3. Reinforce cabinet bottom with wood stips
if additional strengthening is required or if
cabinets are framed.
4. Remove baffle filters from hood.
Also remove side panels from hood using
a Phillips screwdriver to remove each of
the screws. And then remove the grease tray.
5. Use 4 wooden screws to secure the hood
to the bottom of the cabinet.
6. Lift hood onto screws located on cabinet
bottom and lock into place. Make sure all
(4) key-holes cover the screws. Tighten
each screw to secure hood to cabinet.
2. Measure and cut out duct and electrical
openings in cabinet or wall to match up
with the hood. Make sure duct opening is
large enough to apply aluminum duct tape.
4.
baffle filters&
side panels
grease tray
duct tape
Fig 1
ductwork
electrical
wood blocking
installation screws
and key-holes
Summary of Contents for PR830AS
Page 2: ......
