38
TURNING ON AND TUNING IN
Turning the set-top on and off
After you have connected the set-top to the AC wall outlet (and switched this outlet ON, if it has a
switch), wait until you can see the time on its front-panel display.
Press the button labeled
power
on the front panel of the set-top to turn it on. The light beside the
power
button lights blue, to show that the set-top is ON.
Tuning the TV and VCR to the set-top
The set-top’s RF output port (labeled “TO TV”) can transmit signals on either channel 3 or channel
4. The cable operator has set up the set-top to transmit on the channel that is suitable for the
installation location and should have told you which channel this is. You must tune the TV and the
VCR to this output channel so that programs can be watched and recorded through the RF coaxial
cables. To do the tuning, refer to the diagram on page 39 and carry out the following steps.
1. Make sure that all the equipment, including the set-top, is turned on.
Make sure that you have NOT selected a baseband input at the TV.
Make sure that the bypass feature is turned off (BYPASS is NOT lighted on the front panel).
2. On the VCR, switch the TV/VCR switch to “TV”.
3. Tune the TV to the set-top’s RF output channel (3 or 4, as stated by the cable operator).
To turn on the set-top,
press the power button.
The light beside the
button lights blue.
Front panel display, showing the
time
Summary of Contents for TDC775D
Page 63: ......
