26
Remove the brake cylinder assembly, and place it on a
clean, dry surface so as not to damage the splines. Refer
to “BRAKE CYLINDER SERVICE” for additional informa-
tion..
Remove the primary sun gear, then remove the cable
drum closure by using two (2) capscrews from the motor
adapter and a short piece of chain. Lift the closure out
of the drum. Remove and discard the O-ring and the
seal. Inspect the bearing for wear. If replacement is
necessary, use a bearing driver to remove the bearing.
15. Lift out the ring gear adapter.
Remove thrust bearing and two races.
Remove the primary planet carrier assembly. Refer to
“PRIMARY PLANET CARRIER SERVICE” for additional
information. Remove the thrust washer that was under
the primary planet carrier.
Lift out the ring gear. Inspect the gear for abnormal
wear or pitting.
Summary of Contents for Braden BP200
Page 46: ......
