4
3. Operation.
After power-up the controller displays the name and version of the software, then
goes to the state it was in before shutting down or lose power.
On the front panel of the controller (Figure ) there is:
1 – display,
2 – STOP button, reset the alarm and cancel the changes,
3 – START button and choose the parameter,
4 – the boiler thermostat knob and set the parameters and click OK,
5 – MENU button and choose the parameter,
6 – ESC / output.
Figure 1. Front panel of RK-2006SPGMS controller.
Basic operation of the device is to set the preset boiler temperature. In this hands.
U need to turn the boiler thermostat knob (4) to set the correct value and confirm it
with the OK button (or press the knob).
CAUTION!
If you enter the room thermostat works in adaptive mode, you try to
change the set temperature of the boiler may end in failure, ie. After approval of the
new value of the controller can automatically change the boiler temperature to a va-
lue that results from the operation of the adaptive algorithm.
CAUTION!
If the heating system has a water heater, the water temperature in the
boiler maintained by the controller during the heating tray may be higher than the set
temperature of the thermostat knob.
Summary of Contents for RK-2006SPGMS
Page 2: ......
Page 34: ...34 Figure RK 2006SPGMS Controller connection diagram...
