12. Install door arms (Fig. 1-32).
FOR SECTIONAL DOORS
– Attach straight arm to carriage.
– Secure with clevis [32] and cotter pin [33].
– Attach curved arm to door bracket.
– Secure with clevis [32] and cotter pin [33].
FOR 1-PIECE DOORS
– Attach curved arm to carriage.
– Secure with clevis [32] and cotter pin [33].
– Attach straight arm to door bracket.
– Secure with clevis [32] and cotter pin [33].
13. Close door completely.
• Make sure emergency release is disengaged.
14. Join door arms (Fig.1-33).
• Overlap door arms.
NOTE: For sectional doors overlap arms as much
as possible. Make arm assembly as long as
possible for one piece doors.
• Move carriage as necessary to align holes.
– Secure with bolts [35] and nuts [36].
15. Adjust emergency release cord .
• Pull cord through carriage lever until knob is
6 feet above floor.
• Tie new overhand knot in cord at carriage lever.
• Cut excess cord.
• Check all hardware for tightness.
16. Install light bulbs (not provided)(Fig. 1-34).
• Remove power from operator (if required).
• Lower lens cover.
– Push in lens latches and pull down on front
of lens cover.
• Do Not use short neck bulbs.
• Use bulbs rated for:
– 60 Watts Maximum.
– Rough service recommend.
• Screw bulbs into light sockets.
NOTE: Do Not overtighten light bulbs in sockets.
Fig. 1-34
Install light
60 WATTS MAXIMUM
NOTE: Use of 130 Volt lights is recommended for
longer bulb life.
LENS LATCHES —
PUSH IN TO RELEASE
SECTIONAL
Curved end
toward
carriage
1-PIECE
Curved end
toward
door
As short as
possible
As long as
possible
Fig. 1-33
Join door arms (track-
Fig. 1-32
Join door arms (track-
3/8"-16 Bolt
3/8"-16 Nut
[35]
[36]
OPEN YELLOW PARTS BAG
33
32
33
32
36
35
33
32
33
32
36
35
17
