25
4. Programming a second PIN
• Open keypad cover fully–LED blinks one time
(Fig. 6-6).
• Enter “1-5-9.”
• Press “PROG”–LED blinks one time per second.
• Enter desired PIN (up to 8 digits).
• Press “PROG”–LED goes out.
• Close cover.
NOTE: The second PIN is used to open and close
door but does not allow the ability to change any
program settings.
5. Program door operator for second PIN
(Fig. 6-5 & 6-6).
• Repeat step 3.
6. Programming a temporary PIN (Fig. 6-5)
• Open cover fully–LED blinks 1 time and
goes out.
• Enter PIN 1.
• Press “PROG”–LED blinks 1 time per second.
• Press “PROG” again–LED blinks 2 times
per second.
• Enter temporary PIN (up to 8 digits).
• Press “PROG”–LED blinks 3 times per second.
• Close cover.
NOTE: When using a temporary PIN, keypad does
not have to be programmed into the operator.
NOTE: Temporary PIN will remain active until the
next time PIN 1 is entered.
CAUTION
Moving door can cause serious injury or death.
• Keep people clear of opening while door
is moving.
• Do Not allow children to play with wireless keypad.
If safety reverse does not work properly:
• Close door and disconnect operator using
emergency release.
• Do not use door operator, remote controls,
or keypad.
• Refer to door and door operator owner’s
manuals before attempting any repairs.
NOTE: Wireless keypad will not close door if STBs
are not working properly.
NOTE: When programming wireless keypad, you
must be at least 24 inches from the antenna.
1. Programming personal identification number (PIN)
(Fig. 6-5).
• Open cover fully–LED lights.
• Enter “3-5-7.”
• Press “PROG”–LED blinks once per second.
• Enter desired PIN (up to 8 digits).
Press “PROG”–LED blinks 2 times per second.
• Close cover.
NOTE: If PIN is forgotten, or to change PIN use
step 2, then repeat step 1.
2. Resetting wireless keypad (Fig. 6-5).
• Open cover halfway–LED does not light.
• Press and hold “PROG” and “8.”
• Open cover fully–LED blinks 1 time and goes out.
• Release “PROG” and “8” and close cover.
COVER FULLY OPEN
Fig. 6-5 Keypad essentials
During programming, door operator could begin to
run, so stay away from moving door and its parts.
To keep door from moving, close door and
disconnect from operator by pulling
emergency release.
PROGRAMMING WIRELESS KEYPAD
Fig. 6-6 Learn code button / indicator
PROGRAM BUTTON
LED
CAUTION
3. Programming door operator (Fig. 6-6).
• Open lens cover on power head.
• Press operator learn code button–LED blinks.
• Open keypad cover fully.
• Enter PIN on keypad.
• Press “SEND” on keypad–LED stays lit on
power head.
• Press “SEND” again–LED on power head
goes out.
• Press “SEND” again–motor runs.
• Press “SEND” again–motor stops.
• Close covers.
NOTE: Any key will control door within 30 seconds
after door begins to move or cover is closed.
LEARN CODE BUTTON
