Visor Clip
Battery
Battery
Cover
23
Fig. 6-1 Replacing battery
1. Install / replace battery (Fig. 6-1).
• Using a pen or similar object, gently push in on tab.
• Cover snaps open. Remove old battery.
• Observe polarity markings (+,-) inside
battery compartment.
• Match new battery to polarity markings and install
new A 23, 12 Volt battery.
• Replace battery cover.
NOTE: Use only A23, 12 Volt battery.
2. Attach visor clip (Fig. 6-1).
• Slide clip in slot on back of remote control.
– Snap in place.
6
...
WIRELESS CONTROLS
FOR HELP-1.800.929.3667 OR OVERHEADDOOR.COM
BATTERY / VISOR CLIP INSTALLATION
1. Program one button remote (Fig. 6-3).
• Locate learn code button and learn indicator on
power head (Fig. 6-2).
– Lower lens cover.
– Locate learn button on back of power head.
• Press and release learn code button on power head.
– Red learn indicator blinks 2 times per second.
• Press remote control button once within 30 seconds.
– Red learn indicator stays lit.
• Press remote control button again.
– Red indicator goes out and memory is stored.
NOTE: If red indicator blinks approximately 4 times
per second, programming has stopped.
If programming stops, repeat above steps.
One-Button
Remote Control
Three-Button
Remote Control
Complete with Battery
OR
Moving door can cause serious injury or death.
• Keep people clear of opening while door is moving.
• Do not allow children to play with remote controls.
If Safety reverse does not work properly:
• Close door and disconnect operator using
emergency release.
• Do not use door operator, remote controls, or
wireless keypad.
• Refer to door and door operator owner’s manuals
before attempting any repairs.
WARNING
Fig. 6-2 Learn code button/indicator
Fig. 6-3 Remote controls. (vary by model)
PROGRAMMING REMOTE CONTROLS
NOTE: Remote controls will not close door if
STBs malfunction.
NOTE: When programming remote control, it must
be at least 24 inches from the antenna.
2. Program multi-button remote (Fig. 6-3).
• Repeat step 1 above “Program one-button
remote” for each button and operator.
NOTE: Each button on a multi-button remote
control is for a different operator. You cannot use
more than one button per door.
OR
Two-Button
Remote Control
23
Model
Number
NOTE: Each remote device must be
programmed separately
