4. Technical specifcations
The Control Panel has the following technical characteristics given in Table 1.
Table 1. Basic technical parameters of Control Panel
Characteristic
Value
МОN2 interface (connection of “Lun-5N”, “Lun-7N”, “Lun-73N” network devices and
“ТК-7”, “ТК-17” telephone communicator according to MON protocol)
1
Maximum number of “Lun-5N”, “Lun-7N”, “Lun-73N” network devices connected
30
Number of zones with termination resistor and resistance control
8
Maximum number of user electronic keys
15
Event queue size
64
Armed state current consumption, max, mA
100
Message mode current consumption, max, mA
700
Maximum net current consumption of external devices (detectors, modules) max, A
1
Resistance of termination resistor, kOhm ±5%
4.7
Open zone voltage, V
5
Voltage of zone with termination resistor, V
2.2
Voltage of primary power source, V
13.8...14
Voltage of backup power source (battery), V
11...14
Battery voltage at which “Battery discharged” message is generated, V
11.2
Power voltage at which device shuts down, V
10.5
Maximum length of communication line between the Control Panel and “Lind-7”
indication and control device when using the cable of "foiled twisted pair" type
with cross section of at least 0.2mm
2
, m
40*
Maximum length of communication line between the Control Panel and “Lind-9”
indication and control device when using the cable of "foiled twisted pair" type
with cross section of at least 0.2mm
2
, m
15**
* – standard multicore cable with the cross section of at least 0.2mm
2
can be used for distances of
up to 5m, in case there is no noise produced by electronic equipment.
** – standard multicore cable with the cross section of at least 0.2mm
2
can be used for distances of
up to 3 m, in case there is no noise produced by electronic equipment.
Note.
“Zone” is a part of the secured facility zone are installed with one alarm zone, where
manual, automatic, combined, burglar detectors and end elements of the alarm in accordance with
the diagrams of facility outftting design.
5. Functions of device terminals
The main board of the Control Panel has the terminals to connect wires and cables (see Table 2 and
connection diagrams on Figures 6, 8, 9, 11).
БААИ.425523.003ИУ
Rev. en_19
5
