![Ortus LUN-7T Installation Manual Download Page 11](http://html1.mh-extra.com/html/ortus/lun-7t/lun-7t_installation-manual_1654840011.webp)
In this case, “ARMED” LED and remote LED outside the facility will start fashing regularly
(fashing interval – 1 sec, fash duration – 0.5 sec). At the same time, a repeated sound reminding of
the need to leave the premises, will be enabled.
When the countdown starts, you shall leave the house/object. Activation of the sensors shall
not be considered as an alarm within the period of delay (its duration is confgurable). You can
control the process of arming observing the remote LED outside the facility.
Attention! If you did not leave the premises before the delay time ended, and the
siren was enabled, you shall touch the reader with the authorized electronic key.
The siren will turn off and arming will be cancelled. ARMED LED will extinct. Arming
can be repeated in a few seconds.
3. If ARMED LED and remote LED are constantly lit, it shall mean the following:
1. Facility has been armed.
2. The related message was sent to CMS and the device received the confrmation from
CMS.
Attention! ARMED LED and remote LED shall not fash within more than 180 seconds.
If this time is exceeded or LEDs are not lit, this means that the facility was not armed for
some reasons.
In this case, the following shall be checked:
1. 1. Signal level and signal quality at the Control Panel's remote antenna installation
place.
2. 2. CMS connection confguration settings.
9.1.5. Disarming
1. To disarm the facility, you shall enter the secured premises through the entrance. There is a
certain interval (its duration is confgurable) between the moment of opening of the entry
door and the moment of response of the alarm.
2. During this time period, you shall come up to “Lind-7” ICD and touch Touch Memory key
reader with the authorized key. After the code of the authorized key is read,
ARMED
LED will
immediately extinct, and the facility will be disarmed.
Attention! If you did not manage to disarm the facility within the time allowed and
the siren was enabled, you shall touch Touch Memory key reader with the authorized key.
The siren will turn off.
ARMED
LED will extinct.
Attention! In case of gaining access to the premises not through the entry door (for
example, if the door lock is broken), the alarm will immediately response with the siren
enabled.
To disable the siren and disarm the facility, you shall touch Touch Memory key reader with the
authorized key.
The siren will turn off. ARMED LED will extinct.
Attention! In any case, when the siren is enabled, a single touch of the authorized key
to Touch Memory key reader will disable it.
БААИ.425523.003ИУ
Rev. en_19
11