Cell address are displayed by glowing of red
ZONE 1...8
and
EVENT REPORTING
LEDs
.
Cell content is displayed by yellow
ZONE 1-8
LEDs.
The command consists of six digits, where the frst three digits are the cell address, and the
last three ones are the cell content.
Example.
To change the content of cell with address
242
to
097
value, enter the
confguration mode (
¬
8
), then input the Installer's password (in this example it is
5892
), and
input
¬
242097
.
The sequence of operations for modifcation of this cell content in this example will be as
follows:
Entry
Installer's password
Number and new content of cell
Exit
¬
8
5892
¬
242097
¬¬
9
The assignment and content of cells is described in the "Instructions on confguring of
“Lun-7T” Control Panel using keypad".
9.2.7. Arming
1. To arm the facility, you shall shut all the doors and windows equipped with detectors.
Attention! If at least one detector (zone) is alarmed, the facility shall not be armed.
When the correct four-digit code is entered, a long signal will be heard and ARMED LED
will not light up. The remote LEDs will fash shortly several times and extinct. Number of
remote LED's fashes (1…8) indicates the frst number of the detector (zone) alarmed. If
there are 9 fashes, it means that arming is prohibited.
In case the keypad is in the area of coverage of the optical detector, you shall stop and stand
still until the detector is in the normal state (detector backlighting must extinct).
Attention! In case all the detectors are in the normal state, while at least one of LEDs
1…8 is lit, the status of zones and detectors shall be checked.
2. When all LEDs of
ZONE1…8
of are lit off, you shall input the authorized four-digit user code
on the keypad.
In this case,
ARMED
LED will start fashing. At the same time, a repeated sound reminding of
the need to leave the premises, will be enabled.
Activation of the detectors shall not be considered as an alarm within the period of delay (its
duration is confgurable).
You can control the processes of arming and transmission of signal to CMS observing
ARMED
and
EVENT REPORTING
LEDs, as well as the remote LED outside the facility.
Attention! If you did not leave the premises before the delay time ended, and the
siren was enabled, you shall input the authorized four-digit code on the keypad.
БААИ.425523.003ИУ
Rev. en_19
17
