18
ENG
To reset the registration information for a handset:
1. Remove the batteries.
2. Press and hold the
button.
3. Insert the batteries and close the battery compartment.
4. Release the
button. The handset display will flash the word TEST and sound with a melody.
5. Press the 5 key. The handset will show the words Not registered on the display.
6. Repeat Steps 1-5 to reset all the other handsets.
To reset the registration information for the base unit:
1. Unplug the base unit from the AC power source.
2. Press and hold the PAGE button
3. Plug in the base unit. The blue charge/in use light will flash.
4. Release the PAGE button after the blue light flashes three times.
5. Reregister all the handsets following the procedure on page 16.
Assigning a name to a handset
You can assign an 8-character name for each handset. The name you assign will display on the LCD
display area for the handset whenever the phone is in standby mode. To assign a name:
1. Press the
button.
2. Press
to select Handset Menu from the options.
3. Press
.
4. Press
to select Handset Name from the options.
5. Press
.
6. Enter the new name for the handset using the chart on page 9 as a guide. Press the
button
to delete the current entry. The maximum length for the name is 8 characters.
7. Press
to confirm your selection.
Note: The handset number will display after the assigned name. For example, if you named
handset 2 “Sally”, it will appear as “Sally 2”. The number cannot be changed.
Tip: To return to standby mode, press and hold the
button.
Setting a default base unit (multiple base units only)
If you cross-register your handset with more than one base unit, you can choose which base unit the
phone will connect with when making or receiving calls. The default setting is for each handset to
connect through the first base station it finds within range. However, if you wish to specify a particular
base unit for a handset, you can change the setting using the instructions below.
To set a default base unit for a handset:
1. Press the
button.
2. Press
to select Setup from the options.
3. Press
.
4. Press
to select Base from the options.
5. Press
to display the number of handsets registered with the current base.
6. Press
or
to select the base unit with which you wish to associate the handset.
• To choose a specific base unit, place a mark [
] next to the number that corresponds to the
base unit through which you wish to connect. For example, if you wish to connect the handset
through Base Unit 2, place a mark [
] next to 2.
