17
ENG
3. Press
to select Registration from the options.
4. Press
.
5. Press
or
to select a base unit number that does not have a check mark (
) next to it.
(Checked numbers have already been registered.)
6. Press
to display the PIN Code? prompt.
7. Enter the security PIN for the handset. The default PIN code is “0000”. For more information
about security PIN codes, refer to page 14.
8. Press
.
Result: The handset display will flash the words Base Search until it locates the base unit. Once
it finds the base unit, the base ID number will display on the handset. The base ID number is the
unique identifying number for your base unit. You do not need to record or remember this
number unless you are trying to register your handset to the base unit of another telephone
system.
9. Press
to end the registration session.
Removing a handset
To remove a handset from your ThermoDECT telephone system:
1. Press the
button on a handset that you do not intend to remove.
2. Press
to select Setup from the options.
3. Press
.
4. Press
to select Remove HS from the options.
5. Press
.
6. Enter the security PIN for the handset. The default PIN code is “0000”. For more information
about security PIN codes, refer to page 14.
7. Press
.
8. Press
or
until the number for the handset you wish to remove is highlighted.
Tip: The handset number is shown on the display when it is in standby mode.
Note: You cannot remove the handset that you are using.
9. Press
.
10. Press
again to confirm your selection.
Clearing all handset and base unit registrations.
If you have registered numerous handsets and base units in your ThermoDECT telephone system, you may
experience problems registering new handsets as your system becomes more complex. Remember that a
single base unit can carry a maximun of 5 handsets, and that you cannot make intercom, 3-way, baby
monitor, or transfer calls between handsets that are registered to two different base units (refer to the
diagram on page 15 for a description). To clear all registrations and reorganize your telephone system,
perform the following procedures. You will have to be re-register the handsets and base units after you clear
the system (refer to page 14 for instructions).
