Operating instructions RPG ONE, RPG 1.5, RPG 2.5
6 Operation
orbitalum tools
gmbh
(02.10)
MT_RPG ONE, RPG 1.5, RPG 2.5_BA_04_790036766_00.doc
29
If the tool vibrates after starting, the cutting speed is too high.
X
Reduce speed (refer to chap. 6.6.2, p. 26).
6.7.3
Facing, feeds and Adjustments
•
Each division means an insertion of 0.1 mm (0.004 inch).
•
Do not exceed clamp thickness of 0.05 mm (0.002 inch) with chip removal.
Excessive feed levels will reduce the speed or even stop the machine (refer
to "Troubleshooting", chap. 8.1, p. 33).
1. Introduce the tool with feed (1) to the tube, until the tool is in contact.
Feed RPG Electric
Feed RPG Cordless
2. When the tool is cutting at the complete face of the tube:
Z
continue the tool with the same pressure further, until the desired
processing result is achieved.
Z
To achieve the optimum squareness and finish, the tool should be
allowed to rotate for 2-3 revolutions without any feed being applied.
6.7.4
Switching off RPG Electric
1. Release ON-OFF switch (2).
The machine stops.
2. Remove plug from power supply.
3. Remove tube from machine (refer to chap. 6.5, p. 24).
Note
Feed with scale
division (1)
2
1
1
