Operating instructions GF 4 (AVM / MVM)
7 Operation
orbitalum tools
gmbh
(01.08)
MT_GF 4_BA_04_790142762_01.doc
41
6. Apply saw blade lubricant to the bevel cutter:
–
up to 2": every 3 cuts,
–
over 2" and with chrome and high-quality steel pipes: after every cut.
Important:
If the pipe comes into contact with drinking water or foodstuffs, only
use Orbitalum Tools lubricating gel for saw blades.
For non-stop operation: after beveling, loosen the hexagon nut on the bevel
cutter to avoid damage caused by tension.
7. Switch the motor on.
8. Carefully turn the motor clockwise using the handle (1) until the pipe wall has
been pierced through.
9. Continue turning rapidly until the pipe has been beveled completely.
10. Switch the motor off and allow the machine to run to a stop.
7.9.3
Cutting the pipe manually and beveling it simultaneously
Pipes with a wall thickness of up to 4.5 mm (0.177 inch) can be simultaneously
cut and beveled.
If using a combination cutter, the cutter motor has to be turned around the
pipe more slowly than during normal cutting, as two tools are being used
at the same time. The working procedure is the same as described in
chapter 7.9.1, p. 39.
If necessary, lubricate the saw blade and the additional cutter again during
work. For non-stop operation: after cutting, loosen the hexagon nut on the
saw blade to avoid damage caused by tension.
Note
Note
1
Summary of Contents for GF 4 AVM
Page 51: ......
