Operating instructions GF 4 (AVM / MVM)
7 Operation
orbitalum tools
gmbh
(01.08)
MT_GF 4_BA_04_790142762_01.doc
27
7.4.1
Saw blade without additional cutter
1. Turn the slide with saw blade all the way down using the hand wheel (1) or the
ratchet (see chapter 7.1.6, p. 23).
2. Insert the pipe so that it almost reaches the saw blade (3) and tighten using the
multifunctional wrench (4).
3. Use the handle to turn the motor upwards for about 30° (clockwise) until the
saw blade is in cutting position.
4. Turn the hand wheel (1) until the teeth of the saw blade (3) protrude about 1 to
2 mm (0.039 – 0.079 inch) inside the pipe (2).
5. If desired, perform a test cut (cutting the pipe, see chapter 7.7, p. 32) check the
cut result and readjust the hand wheel (1) if necessary.
1-2 mm
2
3
6. Turn the motor back to its home position.
Scale of the hand wheel: a readjustment by one graduation mark will result in a
radial feed or bevel alteration of 0.1 mm (0.0039 inch).
Note
1
4
3
30°
1
3
Summary of Contents for GF 4 AVM
Page 51: ......
