Oracle Sun Blade X6275, Service Manual

Page: 85 / 116

Chapter 4 Returning the Server Module to Operation 4-5
FIGURE 4-3
Front Panel OK LED and Power/Standby Button
TABLE 4-1
Power-On Procedures
Power On Method
Apply standby power Place the server module into the chassis. See Section 4.2, “Reinstalling the Server
Module in the Sun Blade Chassis” on page 4-3 .
When the main power is off, the server module green OK LED on the front panel
blinks once every three seconds, indicating that the server module is in standby
power mode. See
FIGURE 4-3
.
Apply main power To apply main power to the server module:
1. Verify that standby power is on.
In standby power mode, the green OK LED on the front panel blinks.
2. Use a pen, or other non-conductive pointed object, to press and release the
recessed Power/Standby Button on the server module front panel.
When the main power is applied to the server module, the green OK LED next to the
Power/Standby Button lights and remains lit. See
FIGURE 4-3
.
Figure Legend
Power LED and Button
1 OK LED – Green
2 Power/Standby Button