Oracle MICROS Workstation 5A, Setup Manual

Page: 93 / 183

3-30 Workstation 5A Setup Guide - Fourth Edition
What’s Inside?
Installing Options
Workstation 5A Hard Disk Kit
Instructions for installing the kit can be found in MD0019-003. To configure
the Workstation 5A with BIOS version Q1000g to boot from a SATA disk, see
below. BIOS Versions Q2010g and Q2011d support SATA drive boot options.
1. If converting a WS5A to the optional SATA SSD, be sure to remove the
USB Hard Drive from J8.
Using both a USB Hard Drive and SATA drive at the same time is not
recommended because it prevents the optional POSReady 2009 Recovery
CF from starting. The Recovery CF expects to recover a USB Hard Drive
or optional SATA Disk. If both are present, it cannot determine which is the
boot device and produces an error message.
2. Enter the System Configuration Utility (as described in Chapter 3) and
select the Boot Tab.
3. In the Boot Device Prioritization (BBS) list, scroll to the first entry (‘USB
Hard Drive’ or ‘SMART eUSB USB Device’) and tap the [-] key until the
field displays [SATA drive 0].
4. Be sure the next device is the [IDE 0/Pri Master] selection.
o The Figure below displays a BBS boot order that will boot from a
SATA disk drive.
Figure 3-24: Booting from a SATA Disk Drive
5. When the Boot Device Prioritization list matches the Figure above,
proceed to the Exit Menu and select ‘Save Settings and Restart’, then ‘Y’
to restart.
o Do not use the ‘Reload WINCE’ or ‘WIN32 Factory Defaults’
available in BIOS Versions Q1000g or Q1010m, it will remove the
[SATA drive 0] from the list.
o BIOS Version Q2010g or Q2011d includes a factory default setting for
the optional SATA disk drive, ‘Reload SATA WIN32 Factory Default
Settings’.